How to Trim the tail on the Blueray 450 Heli using the stock Gyro
Disconnect 2 wires to themotor when working initially to inspect the tail.
Set gain of gyro on VrB to about 9 oclock.
Turn on Tx
plug in battery to Helicopter and don't move helicopter or Tx sticks until the gyro light turns blue.
Using
the trim tab on the Tx, move the trim tab until the tail slider is not
moving while the helicopter is sitting still and the tail slider is
approximately in the middle.
Plug motor back in before taking off.
After you place the helicopter down in the launching area, re-center the tail slider using your left stick (not the trim tab).
Get
the helicopter light on the skids and adjust the trim tab for the tail
as needed. While spooling up, it is normal for the tail to possibly
want to spin on you. If it does, try to spool up slower and user your
left stick to correct tail movement as it spools up.
If
your tail is not moving when you are light on the kids, the tail should
not be spinning very much (it may, but should not move the helicopter
more than 45 degrees in about 15-20 seconds).